User manual SAFETY INFORMATION TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. Attention Failure to comply with the specified precautionary measures may cause serious injury to persons or damage to property. The installation and commissioning may only be performed by suitably qualified persons, technicians or installers in compliance with safety regulations.
Page 3
User manual Installation Read and Follow Instructions- All the safety and operation instructions should be read before the set-top box is operated. Follow all operating instructions. Retain Instructions- The safety and operating instructions should be retained for future reference. Heed all Warnings-Comply with all warnings on the set-top box and in the operating instructions. Polarization- Some set-top box are equipped with a polarized alternating current line plug.
Page 4
User manual Installation - continued Outdoor Antenna Grounding- If an outside antenna or cable system is connected to the set-top box, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No.70- 1984 (Section 54 of Canadian Electrical Code, Part1) provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antennadischarge unit, connection to grounding electrodes, and requirements for the grounding electrode.
User manual 1. Introduction 1.1 Front panel USB->Port Standby button 1.2 Rear panel ANT IN: TV aerial for an external TV aerial ANT OUT: RF loop through, for an external device COAXIAL: Coaxial digital audio HDMI Output SCART TV SCART for connection to the TV AC MAINS...
Page 7
User manual 1.3 Remote control Button Function Switch the STB on and standby Power RED/GREEN/ For interactive function/Submenu YELLOW/BLUE function buttons MUTE Turn off/on the volume Rewind the playback ►► /◄◄ Fast forward the playback Skip Backward ►►I / I◄◄ Skip Forward ►...
User manual 1.4 Connecting the TV 1.5 Connecting a HIFI system 1.6 Init Install If you use the STB for the first time, the "Init Install" menu appears . Press cursor button to setup the OSD Language, Country,Time Zone, Active Antenna and LCN.
User manual 1.7 Installation Press the "MENU" button to enter main menu. Press "UP"or " DOWN " button to highlight "Installation", press "RIGHT" button to enter the Installation menu. Press "UP" or "DOWN" cursor button to highlight the desired item and press "OK"button to enter the sub-menu .
User manual Operation 2.1 Switching Channels You can change channels by: Pressing the CH+/CH- buttons. Entering the channel number using the NUMERIC(0-9) buttons. Pressing "OK" button to enter channel list, then press "UP" and "DOWN" buttons to select channel. 2.2 Hotkey In TV viewing mode, you can do the following: ...
User manual 2.5 Favorite List In the Channel menu, Highlight"Favorite List", press "OK" button to enter Favorite List menu. Press "UP" or "DOWN" button to highlight channel. Press Red,Green, Yellow,Blue color buttons to add the channels to Fav1~Fav4 List. An icon indicates which channel be choosed as favorite channel.Press corresponding color button again to cancel.
User manual Preference 3.1 Preferences Press the "MENU" button to enter main menu. Press "UP"or "DOWN " button to highlight "Preference", press "RIGHT" button to enter the Preference menu. Press "UP" or "DOWN" cursor button to highlight the desired item ...
User manual Settings 4.1 Invoke Settings Press the "MENU" button to enter main menu. Press "UP"or "DOWN " button to highlight "Setting", press "RIGHT" button to enter the Setting menu. Press "UP" or "DOWN" cursor button to highlight the desired item and press "OK"button to enter the sub-menu .
User manual 4.4 Date Time Date Time Mode: Auto/Manual Date/Time: In "DateTime Mode" Manual mode, you can set date and time manually. Highlight "Date" or "Time",press "Right" button to select,then set by the numeric button. In "DateTime Mode" Auto mode, you can set Time Zone. The GMT offset range is "Auto/-12:00 ~ +12:00", increasing Time Zone: half hour progressively.
User manual AV & Mediacenter 5.1 Audio & Video This menu allows you to set Audio and Video item. Press the "MENU" button to enter main menu. Press "UP"or "DOWN " button to highlight "AV", press "RIGHT" button to enter the AV menu. ...
User manual 5.2 Media The product supports 7 types of Media lists. Press the MEDIA button to enter Multi Media mode. Press"RIGHT" or "LEFT" button to highlight each list, then press "DOWN" button to enter the list. In List menu, press cursor button to browse folders and files. ...
Press "BACKWARD" button to rewind the playback Stop the Time Shift Press "STOP" button to stop TimeShift. Note: For recordings/timeshift: Please select a USB 2.0 HDD or USB stick, from a recognized brand, as TRIAX can’t guarantee non recognized brands to function as intended !
User manual Troubleshooting WARNING In some regions, digital terrestrial signals may be weak. It is therefore advisable to use an antenna amplifier to boost weak signals. Problem Possible cause / What to do Standby light not lit Check mains lead Mains lead unplugged ...