To Remove The Paper Roll - ADEMCO 6220 User Manual

Example 1:
Example 2:
User Programmable By using CHR$(1) you enter the Custom Char-
Character 19 acter mode. This allows you to design and print
your own 6 x 8 character by inputting data. A
DATA statement is made of numbers that rep-
resent a row of dots which when READ all to-
gether, will make up your character. To design
your character, follow the example below. You
should notice that each number in the DATA
statement corresponds to one row in your char-
acter. To design a character, follow these steps:
27
12. Put the paper spindle into the paper roll as
shown below, and place the roll with the
spindle onto the snaps near the back of the
printer. Turn the paper roll to take up any
slack in the paper feeding to the printer.
Make sure the roll of paper turns freely. If it
does not turn freely, the paper will jam and
will
mechanism.
1. Advance the paper about one inch beyond

To Remove the Paper Roll

the paper cutter by using the Paper Feed
switch.
2. Lift the paper roll away from the printer
housing and cut the paper feeding to the
printer with scissors. Try to make the cut as
square as possible to help the next time you
reload the paper.
3. Pull the remaining paper through the printer
mechanism. Be sure to pull the paper fro
the top the top
the top the top the top (paper cutter side).
W W W W WARNING! ARNING! ARNING! ARNING! ARNING! Pulling the paper out of the back
of the printer will damage the print mechanism
possibly damage the printer
Be sure to pull the paper fro Be sure to pull the paper fro
Be sure to pull the paper fro Be sure to pull the paper fro
4