ADEMCO 6220 User Manual page 16

L L L L L O O O O O AD DEF AD DEF AD DEFA A A A A UL AD DEF AD DEF
Load Defaults
reset the printer to all default settings (shown
below).
The complete list of
defaults is shown in
the Default Table at
the end of this manual.
* The parallel interface does
not have these selections
Choose OK
parameter. The following is printed:
Baud Rate
Baud rate is the next parameter you can set in
the configure menu. The complete list of
parameters and their possible values is shown
below.
The sample list above shows the current baud
rate is 1200. To accept this, press OK
or view the next baud rate value by pressing
NEXT (left side). Press OK when the baud rate NEXT NEXT NEXT NEXT
you want is displayed.
Choose from these baud rates:
300, 600, 1200, 2400, 4800, 9600, or 19200
11
ULTS UL UL UL TS TS TS gives you the opportunity to TS
OK to do this or NEXT OK OK OK NEXT NEXT NEXT to go to the next NEXT
OK (right side) OK OK OK
Equivalent to DB-25S (Canon)
On the cable: 25-pin plug
Equivalent to DB-25P (Canon)
Shell: Equivalent to DB-C2-J9 (Canon)
2. Cable
Use cable less than 500 feet long Use cable less than 500 feet long. . . . . A shielded Use cable less than 500 feet long
Use cable less than 500 feet long Use cable less than 500 feet long
cable using twisted pair conductors is
desirable.
Model 6220P
Parallel Version
PIN NO PIN NO PIN NO PIN NO PIN NO. . . . . SIGNAL SIGNAL SIGNAL SIGNAL SIGNAL DIRECTION DIRECTION DIRECTION DIRECTION DIRECTION
1 Data Strobe To Printer
2 Data Bit 1
3 Data Bit 2
4 Data Bit 3
5 Data Bit 4
6 Data Bit 5 To Printer
7 Data Bit 6
8 Data Bit 7
9 Data Bit 8
10 Acknowledge From Printer
11 Busy From Printer
16-29 0 Volts
12 0 Volts From Printer
13 +5V From Printer
32 +5V From Printer
The rest are not used
DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION
Samples input data when held
low for 10 microseconds
Indicates Input Data
High level indicates "l" and
low level "0"
Indicates character input
completion at low level
Indictes data cannot be
received at high level
- Twisted pair return (for pins
1 to 11)
High = Out of paper
High = Printer selected
Low Level = Error condition
20