Advertisement
24 H
T
OUR
Programming Guide - Tactic Synchronous & Quartz
Setting Up -
The Outer dial will need to be set to the current time (when the heater
has been installed and has a constant power supply). Rotate the minute hand slowly
in a clockwise direction, until the correct hour is located at the tip of the arrow
printed on the dial. See Figure 1 below.
Please note that the outer dial is printed with the 24 hour clock i.e. 8:00 am = 8 on
the dial. 8:00 pm = 20 on the dial.
Minute Hand (pointing to arrow printed on dial)
Figure 1
Tappet
Programming Switching Times -
time you will need to position the appropriate tappets to your required on and off
times. The factory set position of all tappets is in the off position, to change any tap-
pets to the on position they must be switched away from the clock face.
See Figure 2 below.
ON
Manual Override -
Your 24 hour timer is also fitted with a manual override
switch that is built into the face of the dial illustrated in Figure 1 (top of this page).
This switch has 3 positions which are explained in the table on the following page.
(If Fitted)
IMER
Outer
Dial
Override
Switch
Once the outer dial has been set to the current
Figure 2
OFF
Switch Position
I = Top Position
Manual Override = ON:
is by-passed, and will not affect the operation of the
heater.
= Middle Position
24 Hour Timer = ON:
0 = Bottom Position
Manual Override = OFF:
will not operate regardless of any other settings.
Important -
The manual override positions are a fixed selection - i.e. the output of
the 24 hour timer will remain ON or OFF (as selected), until the switch is returned
T
EMPERATURE
The digital thermostat displays the temperature in ˚C.
4
TLZ 11
U
P
OUT
AL
5
1
D
T
IGITAL
HERMOSTAT
The digital thermostat fitted to your Elecro Aquatic heater, has been pre-
programmed with all the necessary parameters to ensure reliable service & opera-
tion.
All you need to do is set the temperature you would like to maintain in your pond
(This is called the set point*).
To display / modify the set point* temperature, press and release the P button (see
diagram on following page).
The pre-programmed set point temperature will be displayed.
Press
(3) to increase or
(2) to decrease the set point*.
Function
In this position the time clock
Timed Operation Only.
In this position the heater
D
ISPLAY
3
1
P Button
Used to display / modify the set point
temperature
2
Down
Used to decrease the set point value
Button
3
Up Button
Used to increase the set point value
4
Not Used
NOT USED
5
LED - OUT
Indicates that the water has fallen below
the set point temperature.
2
I
NSTRUCTIONS
Advertisement
