Table of Contents
Advertisement
P
OSITIONING
Your Elecro heater must be screw fixed to a firm base or wall. The heater MUST be
horizontal and upright i.e. with the control enclosure located above the Titanium
flow tube (see diagram below). Under no circumstances should the heater be oper-
ated in any other orientation.
The heater can be installed on both pump and gravity fed systems. It should
be installed at a low point in the
build up inside the heater it must be sited after, i.e. downstream, of the filter.
NOTE If the
Only clean filtered water
flow direction
should enter the heater.
is reversed
(explained
later in this
booklet) the
heater MUST
remain sited
after the filter.
NB Diagrams do not show
the digital thermostat
system. To limit weed and debris
filtration
N
OTES
[Blank Page For Your Notes]
Advertisement
Table of Contents
Need help?
Do you have a question about the Titanium and is the answer not in the manual?
Questions and answers