Eastwood TIG 200 DC WELDER Assembly & Operating Instructions page 4

ELECTRICAL SAFETY DON'TS
• Never bypass the ground plug. Grounding is necessary for proper operation of the unit and reduces shock hazard.
• Do not touch the torch tip until after the activation switch is off and the unit is UNPLUGGED.
• Do not use the unit if any component should become damaged or show signs of excessive wear.
• Never handle the torch and the feed cable, power cord or welder cabinet at the same time. Fatal shock can occur.
• Avoid welding in extreme humidity or while heavily perspired.
• Do not wrap welding cables around your body
UV AND IR RAY DANGERS
The ARC welding process produces Ultra Violet (UV) and Infrared (IR) Rays that can injure your eyes and skin. Do not
look at the welding arc without a minimum #10 eye shade and skin protection.
• Always weld with a helmet that covers your entire face and neck.
• Always use a helmet with a lens of Shade 10 or darker.
• Always cover all bare skin with protective clothing. Flame retardant clothing is always the best.
• Never allow anyone around the area you are welding without proper protection.
HOT MATERIALS DANGERS
Materials being welded are very hot and can cause severe burns if handled improperly.
• Do not touch welded materials with your bare hands, use great caution when lifting a piece with gloves.
It is best to allow the part to cool completely before handling.
• Do not touch the electrode, electrode holder, or ground clamp with bare hands until it has cooled.
HAzARDOUS FUMES AND GASES DANGER
• Keep your head out of the fumes.
• Use ventilation or an exhaust system to keep the fumes and gasses from your general and breathing area.
• Do not weld painted or plated parts as they can release toxic gases or fumes.
4