Connections - Panasonic TH-42PH10EK Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
(Example: TH-42PH10EK)
Speakers (Optional accessories)
SPEAKERS
Terminals (R)
Note:
Make sure that the AC cord is locked
on both the left and right sides.
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
R L R
AUDIO AUDIO
S VIDEO
B AV IN
SLOT1
Dual Video Terminals (equivalent
of BNC Dual Video Terminal Board
(TY-FB9BD)) (see page 11)
Notes:
• On TH-42PH10EK/S, TH-50PH10EK/S and TH-58PH10EK, Terminal board is installed in SLOT 1 at factory shipment.
• On TH-42PS10EK/S, SLOT 1-3 are all empty at factory shipment.
8
AC cord connection
(see page 12)
– AC cord fi xing
Plug the AC cord into the display unit.
Plug the AC cord until it clicks.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
L
VIDEO
A
SLOT2
Optional Terminal
Board Insert Slot
(covered)
SPEAKERS
Terminals (L)
Unplug the AC cord
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet fi rst.
To tighten:
Pull
SLOT3 PC IN
From EXTERNAL
monitor terminal on
Computer (see page 9)
1
2
1
2
Unplug the AC cord
pressing the two
knobs.
To loosen:
Push the catch
Pull
AUDIO
SERIAL
From SERIAL Terminal
on Computer
(see page 10)