Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Spinfire Pro 2
Summary of Contents for Spinfire Pro 2
- Page 1 Pro 2 Manual...
-
Page 2: Before First Use
BEFORE FIRST USE To protect the machine in transport, the internal pivot plate may have been secured to prevent it from moving. Please remove any cable ties or bolts prior to turning the machine on. You can locate these by following the ribbon tied to the transport handle back to its location. - Page 3 Packaging We recommend you keep your box in case you need to ship your machine back to the supplier at a future point in time. CHARGING The machine should arrive to you fully charged, however, if you have time, we encourage you to charge the machine before its first use.
-
Page 4: Customer Care
We recommend that your machine is stored inside/under cover and preferably in a Spinfire cover to protect it from debris. Do not leave your machine on court even with the protection of a cover as heavy rain may damage your machine. - Page 5 (above the control panel). To assist with transporting your machine, you can purchase a Spinfire Carry Case which has handles and pockets for storing your charger, remote control and accessories.
-
Page 6: Control Panel
CONTROL PANEL Power: Press this button to start the machine (hold it for 3 seconds). Please note that there is a main power switch underneath the machine. Please make sure this is on before operating your machine. The main power switch should be switched off when transporting or storing the machine. - Page 7 start ejecting from the machine until you press the feed (start/stop) button. Ball Speed: This sets the speed at which the balls are propelled. It can be set from 0 – 20 with 20 being the fastest speed (approximately 80mph or 130km/h). Spin: Using this setting, you can add topspin or slice to each ball.
-
Page 8: Remote Control
press it again, you will enter the 2 line drill medium mode which alternates between a medium forehand and a medium backhand (easier). Pressing the button a 3 time will enter the 2 line drill narrow mode which alternates between a narrow forehand and narrow backhand (easiest). -
Page 9: Example Settings
Balls can contain an oily coating in the felt which can cause damage to the throwing wheels rendering them useless. Please choose carefully when determining which balls to use in your machine. We endorse Spinfire Juice, Tretorn Micro X & Babolat Academy balls which have been thoroughly tested with this machine. -
Page 10: Troubleshooting
3. You are now ready to start filming. While filming the front of the machine, please turn it on. The Spinfire Pro 2 should lower the elevation and then move to the side (if standing in front of the machine, it will move to the right). - Page 11 If you are finding regular jamming, please consider the tennis balls that you are using. We strongly recommend the use of Spinfire Juice, Tretorn Micro X or Babolat Academy balls as we have found these to be the most trouble free. Old balls and less expensive balls are more prone to jamming and could be the cause of your problem.
-
Page 12: Warranty
WARRANTY Should any part (excluding the battery) fail due to defective workmanship or faulty materials within the warranty period, Spinfire or its distributor will repair or, (at distributors option), replace the defective part free of charge. The warranty period is country specific, please contact the Spinfire distributor in your country or the place of purchase for details. - Page 13 are paid by the owner. No liability is accepted for loss or damage during transit. 2. The machine must always be operated and maintained in accordance with the instructions supplied. 3. No alterations or repairs have been carried out without obtaining the distributors prior consent.
Need help?
Do you have a question about the Pro 2 and is the answer not in the manual?
Questions and answers
Los rodillos no cogen la bola