Table of Contents
Advertisement
TV
VCR 1
TUNER
VCR 2
TAPE
DVD
SAT
M
AMP
CD
TV
OK
ZOOM
P
To select connected equipment
If the monitor is connected to a video recorder with the EasyLink function, in some
cases the monitor will be switched on, even when it was in standby. (E.g. playback
tape,...)
This is not possible when Child lock On is selected.
Equipment connected with an aerial cable only :
Select the programme number under which you have stored the test signal
with the digit keys.
Equipment connected to a euroconnector, to the
connector or to the front side of the receiver box
Press the
key repeatedly to select
according to where you connected your equipment at the back or the front
side of your receiver.
Remark : Most equipment (decoder, video recorder) carries out the switching itself.
If you want to change to TV channels?
Enter the programme number of the TV channel which you want to watch
with the digit keys.
VGA menu
Select
with the
VGA
Press the red (picture menu), green (sound menu) or yellow (features menu)
key on the door of the remote control to switch on the
(or press the
MENU
Select one of the PC symbols with the cursor up/down:
for contrast,
for brightness,
for colour temperature,
for horizontal picture position,
for vertical picture position,
for volume.
Press the cursor left/right to alter the selected adjustment.
Press one of the coloured keys again (or the
remote control) to switch off the
Connect peripheral equipment
,
EXT1
EXT2, EXT3, FRONT
key.
key on the simplified remote control).
MENU
menu.
VGA
VGA MONITOR IN
or
,
VGA
menu
VGA
key on the simplified
25
Advertisement
Table of Contents
