Table of Contents
Advertisement
6.4
Troubleshooting
Follow the steps bellow to troubleshoot connectivity problems between source and target DRs.
a.
Issue the following command to the target command to troubleshoot connectivity:
replication -- troubleshoot --peer <ip_address>
administrator@DR1 > replication --troubleshoot --peer 10.250.243.222
Testing connection to port 9904... Connected!
Testing connection to port 9911... Connected!
Testing connection to port 9915... Connected!
Testing connection to port 9916... Connected!
Replication troubleshooting completed successfully - Connection to all ports is OK!
b.
Make sure the management interface is up and reachable by using the following command:
telnet<manamgent_ip>
40
DR4100 Best Practice Guide | April 2014
Example
Advertisement
Table of Contents
