Dell DR4100 Best Practices Manual page 22

b.
22 DR4100 Best Practice Guide | April 2014
administrator@DR1 > network --factory_reset --auto_bonding_speed 1G
WARNING: This will stop all system operation and will reset the network configuration to
factory settings and will require a system reboot. Existing configuration will be lost.
Password required to proceed. Please enter the administrator password:
Resetting network configuration, please wait....
Reboot the system using the command 'system --reboot' to complete the network factory
reset
administrator@DR1 > system --reboot
Please enter administrator password:
Broadcast message from root (pts/2) (Tue Nov 19 17:43:07 2013):
The system is going down for reboot NOW!
Use the following command to verify that bond0 now consists of two 1GB interfaces:
network – show
administrator@DR1 > network --show
Automatic bonding speed: 1G
Device
Enabled
Link : yes
Boot protocol
IP Addr
Netmask
Gateway
MAC Addr
MTU
Bonding options
Member Interfaces
eth0 MAC
eth0 Max Speed
eth0 Speed
eth0 Duplex
eth1 MAC
eth1 Max Speed
eth1 Speed
eth1 Duplex
Example
Example
: bond0
: yes
: dhcp
: 10.250.242.173
: 255.255.252.0
: 10.250.240.1
: BC:30:5B:F3:22:74
: 9000
: "mode=balance-alb miimon=100 xmit_hash_policy=2"
: eth0,eth1
: BC:30:5B:F3:22:74
:1000baseT/Full
:1000Mb/s
:Full
: BC:30:5B:F3:22:75
:1000baseT/Full
:1000Mb/s
:Full