Other Operations And Settings; Activate Backlight; Beep Tone On / Off; Replace Battery - Oregon Scientific ECG Monitor SE332 User Manual

To delete memory:
. Press MODE/- repeatedly to select "MEM".
2. Press +/ST/SP repeatedly until "DELETE" will be
displayed.
3. Press MODE/- to confirm.
DONE indicates the record has been cleared.
MODE/-
When starting an exercise and memory is full, "FULL" will be
displayed, followed by "DELETE".
•
Press MODE/- to delete all records
OR
•
Press +/ST/SP to ignore and start an exercise without
recording data for it.

OTHER OPERATiONS AND SETTiNGS

ACTivATE BACKLiGHT

Press EL/LOCK. (Press any key to extend backlight for
another 5 seconds).
NOTE
The backlight function will not operate if " " is
displayed.
+/ST/SP
MODE/-

BEEP TONE ON / OFF

When time is displayed, press +/ST/SP to activate /
deactivate beep tone.
indicates beep tone is deactivated.

REPLACE BATTERY

If the battery power of your watch is low, the watch will
display: .
To replace watch battery:
. Use a coin to open the battery compartment lid by
turning it anticlockwise.
2. Remove the old battery and insert a new CR2032, 3V
lithium battery.
3. Secure the lid by turning the coin clockwise.
iMPORTANT
Remember to set the profiles after every
battery replacement or reset.
9