Messages - Sony CDX-G3200UV Operating Instructions Manual

The sound is intermittent.
 The sound may be intermittent at a high-
bit-rate.
 DRM (Digital Rights Management) files
may not be playable in some cases.
Audio file cannot be played.
 USB device formatted with file systems
other than FAT16 or FAT32 are
unsupported.*
* This unit supports FAT16 and FAT32, but some USB
device may not support all of these FAT. For
details, refer to the operating instruction of each
USB device or contact the manufacturer.
Operations for skipping an album,
skipping items (Jump mode), and
searching a track by name (Quick-
BrowZer) cannot be performed.
 These operations cannot be performed
when a USB device in Android mode or
iPod is connected.
– Set [USB MODE] to [MSC/MTP] (page 11).
– Remove the iPod.
 The USB mode of the device is not set to
the appropriate mode.
– Make sure that the USB mode of the
device is set to MSC/MTP mode.
The sound cannot be output during
playback in Android mode.
 While the unit is in Android mode, the
sound outputs only from the Android
smartphone.
– Check the status of the audio playback
application on the Android smartphone.
– Playback may not perform properly
depending on the Android smartphone.

Messages

The following messages may appear or flash
during operation.
CD ERROR: The disc cannot be played. The
disc will be ejected automatically.
 Clean or insert the disc correctly, or make
sure the disc is not blank or defective.
CD NO MUSIC: There is no playable file. The
disc will be ejected automatically.
 Insert a disc containing playable files
(page 15).
CD PUSH EJT: The disc could not be ejected
properly.
 Press  (eject).
HUB NO SUPRT: USB hubs are not
supported.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during
iPod playback.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start
playback.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA
(Android Open Accessory) 2.0 is
connected to the unit while [USB MODE] is
set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 11).
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC
to select another source.
 The USB device has a fault, or an
unsupported device is connected.
READ: Now reading information.
 Wait until reading is complete and
playback starts automatically. This may
take some time depending on the file
organization.
USB ERROR: The USB device cannot be
played.
 Connect the USB device again.
19
GB