How To Connect A Pc With Dett To An Intellivue - Philips MPX2 Instructions For Use Manual

2 DETT - Instructions for Use

How to connect a PC with DETT to an IntelliVue

The following chapter describes how to connect a PC using DETT to an IV or IV Network, either via
LAN, LAN / RS-232 converter, RS-232 direct connection or USB/RS-232 adapter.
WARNING
All external devices in the patient vicinity must comply with IEC 60601-1:1988/A1:1991A2:1995 or
EN 60601-1:1990/A1:1993/A2:1995. This applies also to all signal connections, entering the patient
vicinity. Additional safety equipment, e.g. isolation transformers might be used.
The installation procedures e.g. for electrical connections as documented in the IntelliVue Instruction
for Use must be strictly followed.
Connecting to an IntelliVue via a LAN Interface
Please refer to the current Revision of the IntelliVue Data Export Interface Programming Guide for
details on how to set up and configure the LAN Interface.
Connecting to the IntelliVue MP20-90 MIB/RS232 Interface
Please refer to the current Revision of the IntelliVue Data Export Interface Programming Guide for
details on how to setup and configure the MIB/ RS-232 Interface.
Connecting an IntelliVue Monitor LAN Interface by using a LAN/
RS232 converter
Please refer to the Instruction for Use of the LAN / RS-232 Converter in use for details on how to
setup and configure a LAN / RS-232 conversion system. Then proceed as described in section
"Connection of an IntelliVue monitor LAN interface"
Connecting an Intellivue Monitor MIB/RS232 Interface by using a
USB / RS-232 Adapter
Please refer to the Instruction for Use of the MIB / RS-232 Adpapter in use for details on how to
setup and configure the USB / RS-232 conversion system. Then proceed as described in section
"Connection of an IntelliVue monitor MIB/RS-232 interface"
For further details on configuration, please refer to the IntelliVue configuration guide (M8000-9306X).
26