Switch Housing - Hunter Hepburn Owner's Manual

Switch Housing

www.HunterFan.com
1.888.830.1326
Feed the wire plug through the center
Screw two housing assembly screws Insert the third screw, found in
hole of the upper switch housing, then
from the hardware bag halfway into
the hardware bag, into place and
wrap keyhole slots around the screws and
the motor housing. It does not matter then tighten all three screws.
twist counterclockwise.
which two screw holes you choose.
Make sure the upper switch housing is securely
attached to the mounting plate. Failure to properly
secure all 3 assembly screws could result in the switch
housing fixture falling.
13
M3641-01 • 12/20/16 • © 2016 Hunter Fan Company