Intended Use; Items Supplied; Integrated Battery - Hilti PD-C Operating Manual

Touchscreen
=
Micro-USB socket, type B
%
Hinged cover
&
Laser exit window
(

3.2 Intended use

The product described is a laser range meter. It is designed to be used for measuring distances. The
measured distances can be used in conjunction with a wide range of calculation functions, e.g. areas,
volumes, minimum/maximum distances, Pythagoras calculations, laying out, etc.

3.3 Items supplied

Laser range meter, wrist strap, soft pouch, short measuring extension, AC adapter with micro-USB cable.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.

3.4 Integrated battery

The product comes with a permanently integrated 3220 mAh Li-ion battery.
The Li-ion battery will typically last for 500 full charging cycles or at least two years of moderate to heavy use.
When the battery is discharged, the charging operation lasts for roughly three hours – provided that the USB
cable and plug adapter supplied by Hilti are used.
Note
If, at the start of the charging operation, the battery was completely or almost completely discharged,
the charging signal may only appear after roughly 30 minutes.
At temperatures over 30 °C (86 °F), the time required to charge the battery will increase considerably. Optimal
battery charging times are achieved at normal interior temperatures, away from direct sunlight.
In the case of very high exterior temperatures, i.e. 32 °C (90 °F) and over, the charging operation will take
longer. The charging operation may even be automatically interrupted in order to maintain a safe battery
temperature.
The charging operation may take longer if the USB cable supplied by Hilti is connected to a PC for charging.
We do not recommend using micro-USB cables from other manufacturers. If this cannot be avoided, you
should first ensure that the cable in question is suitable for use with 5.0 V/2.1 A power sources. The time
required to charge the tool may be significantly increased if a different make of micro-USB cable is used. If a
micro-USB cable from another manufacturer is regularly used in place of the one supplied by Hilti, this may
impair the battery life.
▶ When starting the tool for the first time, ensure that the battery is completely charged before putting the
tool into operation.
▶ Do not charge the tool in direct sunlight.
▶ If the charging operation stops or is taking a very long time, try to find a cooler environment in which to
charge the battery.
▶ If there is anything unusual about the battery charging operation or if the battery life falls below two
hours, contact your Hilti Service team.
▶ The tool should only be charged using the micro-USB cable supplied by Hilti. Connect the cable to a
USB port on a PC or, using the plug adapter supplied, a power outlet.
▶ If you lose the micro-USB cable or the plug adapter supplied with the tool, contact your Hilti Service
team for a replacement.
WARNING
Risk of injury caused by the laser beam. Failure to follow the correct procedures when opening may
cause uncontrolled emission of laser radiation.
▶ Always have repairs carried out by Hilti Service.
▶ The Li-ion battery must be replaced by Hilti Service as the tool has to be reconfigured once the battery
has been replaced.
10 English
Printed: 10.11.2016 | Doc-Nr: PUB / 5270043 / 000 / 04
Camera lens
)
Glass cover
+
Tripod thread
§
Image-recording camera (PD-CS)
/