Wifi Settings; Network Settings; Troubleshoot With The Leds; Standard Led Behavior When The Router Is Powered On - NETGEAR R6900P User Manual

WiFi Settings

Make sure that the WiFi settings in the computer or mobile device and router match exactly. The WiFi
network name (SSID) and WiFi security settings of the router and computer or mobile device must match
exactly.
If you set up an access control list, you must add the MAC address of each computer or mobile device to
the router's access control list (see

Network Settings

Make sure that the network settings of the computer are correct. Wired computers and computers that are
connected over WiFi must use network IP addresses on the same network as the router. The simplest way
to do this is to configure each computer to obtain an IP address automatically using DHCP.
Some service providers require you to use the MAC address of the computer initially registered on the
account. You can view the MAC address on the Attached Devices page.

Troubleshoot With the LEDs

By default, the router is set with standard LED settings. If you turned off the LEDs except the Power LED,
you must return the LEDs to their standard settings for troubleshooting. For information about controlling
the LED settings, see

Standard LED Behavior When the Router Is Powered On

After you turn on power to the router, verify that the following sequence of events occurs:
1.
When power is first applied, verify that the Power LED
2. After about two minutes, verify the following:
• The Power LED is solid white.
• The Internet LED is lit.
• The WiFi LED is lit unless you turned off the WiFi radios.
You can use the LEDs on the front panel of the router for troubleshooting.

Power LED Is Off or Blinking

This could occur for a number of reasons. Check the following:
• Make sure that the power adapter is securely connected to your router and securely connected to a
working power outlet.
• Make sure that you are using the power adapter that NETGEAR supplied for this product.
• If the Power LED blinks slowly and continuously, the router firmware is corrupted. This can happen if a
firmware upgrade is interrupted, or if the router detects a problem with the firmware. If the error persists,
it is likely that a hardware problem exists. For recovery instructions or help with a hardware problem,
contact technical support at
Nighthawk AC1900 Smart WiFi Router Model R6900P
Allow or Block Access to Your Network
Disable LED Blinking or Turn Off LEDs
netgear.com/support.
Troubleshooting
on page 52).
on page 160.
is lit.
203