Resetting the IP Address of the Machine
If the message <Cannot connect to the server. Contact the system manager.>
persists on the display after the machine is turned ON, the IP address of the
machine may not be properly set. Resume communications between the machine
and the uniFLOW server by resetting the IP address of the machine as described
below.
1
Press
2
Press [OK] to open the <Network Settings> menu.
● If a screen prompting you to enter the System Manager ID and System
Manager PIN appears:
❑
Select <Manager ID> using [ ] or [ ] and press [OK].
❑
Enter the System Manager ID using the numeric keys and press [OK].
❑
Select <PIN> using [ ] or [ ] and press [OK].
❑
Enter the System Manager PIN using the numeric keys and press [OK].
❑
Press
NOTE
The System Manager ID and System Manager PIN are both set to '7654321' as
default.
3
Check the IP address of the machine and set it on <Network
Settings>.
NOTE
Set the IP address of the machine depending on the network environment you are
using.
4
Restart the machine.
Turn OFF the machine and wait at least 10 seconds before turning it back ON.
EN-7
Managing the Machine with the uniFLOW Integration
(Menu).
(Log In/Out).