Audi A8 2003 Workshop Manual page 26

Audi A8 2003 ➤
10-cylinder direct petrol injection engine (5.2 ltr. 4-valve), mechanics - Edition 10.2013
– Remove A-pillar trim (right-side) ⇒ Rep. gr. 70 .
– Fold back floor covering.
– Unbolt protective cover above main fuse holder.
– Fold cover -2- to side.
– Remove nut -4-.
– Detach terminal 30 wire to starter.
Note
Disregard items -1- and -3-.
– Unscrew wiring clamp -1- in wheel housing (front right).
– Pull wiring harness out from interior -arrow-.
– Unplug electrical connector -2-.
– Unbolt earth cable -1- at longitudinal member.
– Unbolt bracket for wiring harness from longitudinal member
-arrows-.
– Move electrical wiring harness clear.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
20
Rep. gr.10 - Removing and installing engine