Important Safety Instructions - DeWalt DCB1800 Instruction Manual

1800 watt portable power station with parallel battery charger
Hide thumbs Also See for DCB1800:
Table of Contents

Advertisement

Available languages

Available languages

English

Important Safety Instructions

SAVE THESE INSTRUCTIONS: This manual contains
important instructions that should be followed during
installation and maintenance of the portable power station/
charger and batteries.
Safety Rules for the Portable Power
Station/Charger
Before using the portable power station/charger,
read all instructions and cautionary markings on the
portable power station/charger, battery pack and
product using the battery pack.

WARNING: Shock hazard. Do not allow any liquid to
get inside the portable power station/charger. Electric
shock may result.

WARNING: Burn hazard. To reduce the risk of injury,
charge only D
WALT rechargeable battery packs.
e
Other types of batteries may overheat and burst
resulting in personal injury and property damage.
Use with D
WALT 20V Max* battery packs only.
e
Do not use under wet conditions or in presence of
flammable liquids or gases.
Do not expose to water, rain, snow, or any type
of moisture.
Do not insert battery packs into charging ports, plug the
portable power station in, or plug any device into the
portable power station's power receptacle if moisture is
detected on or in the portable power station/charger.
Do not let children come into contact with the device.
Supervision is required when inexperienced operators use
this device.
Place the portable power station/charger on a stable, flat
surface where it will not fall or tip over.
Never connect the portable power station/charger
output to a structure's electrical system. Connecting
electricity through a building's electrical system to the
outside utility feed lines could result in fire, electrocution or
endanger repair persons attempting to restore service.
ALWAYS operate portable power station/charger in
a clean, dry, well ventilated area. Make sure hands are
dry before touching unit. Water can conduct electricity!
Water which comes in contact with electrically charged
components can transmit electricity resulting in electrical
shock to anyone contacting them.
ALWAYS ensure that the portable power station/charger
Charger-in cord is easily accessible during operation to
allow for quick disconnection from the mains.
Inspect extension cords before use and replace with
new cord if required. Contact with worn or damaged
extension cords could result in electrocution.
Do not expose the portable power station/charger
to wet or damp areas. Use only in a dry location. Do
not allow any liquid to get inside the portable power
station/charger. Do not submerge the portable
power station/charger in any liquid.
ALWAYS use grounded extension cord(s) of proper
size (wire gauge) corresponding to rated AC current on
2
nameplate of portable power station; see important
safety instructions for the Portable Power station/
Charger. Use of undersize extension cord(s) could result
in overheating of the wires or attached items, resulting
in fire.
To prevent electric shock, use only with an extension cord
compliant with local electrical codes for the operating
environment.
Do not operate portable power station/charger with
mechanical or electrical problem. Attempting to use
the unit when it has been damaged, or when it is not
functioning normally could result in fire or electrocution.
NEVER leave portable power station/charger on and
unattended. Unattended operation of this product could
result in personal injury or property damage.
ALWAYS keep cooling air vents (Fig. A,
of any obstructions. Materials placed against or near
the portable power station/charger can interfere with its
proper ventilation features causing overheating.
NEVER suspend the portable power station/charger. The
portable power station/charger is not designed to be
suspended.
NEVER stand on the portable power station/charger. Do
not use it as a stool.
The preferred position of the portable power station/
charger is on its feet or on its back. Do not operate the
portable power station/charger balanced on its side.
Make sure that the summation of electrical loads for
all attachments does not exceed the load rating of the
portable power station/charger. Exceeding the load
capacity of the portable power station/charger by
attaching too many items, or items with very high load
ratings to it could result in overheating of some items or
their attachment wiring resulting in fire or electrical shock.
Do not use portable power station/charger to power
medical or other critical devices.
Unsafe op er a tion of your portable power station/charger
could lead to se ri ous in ju ry or death to you or others.
The portable power station/charger is equipped with two
side handles at the top and a front handle. ALWAYS use
proper lifting practice to reduce risk of injury.
The portable power station/charger outputs a modified
sine wave. Please check with your device's manufacturer
for compatibility. Do not use the portable power station/
charger if device will not function properly with a modified
sine wave as its input.
The label on your portable power station/charger may include
the following symbols. The symbols and their definitions are
as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
 10 
,
 11 
) clear
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts

Advertisement

Table of Contents
loading

Table of Contents