Cancel The Programme; Programme End During Rinse Hold; Programme End; Removing Laundry/Switching Off The Appliance - Siemens WM4UH SERIES Instruction Manual And Installation Instructions

Cancel the programme

For programmes at high temperatures:
Touch the I button.
1.
To cool down laundry: Select
2.
q Rinse.
And touch the I button again.
3.
For programmes at low temperatures:
Touch the I button.
1.
Select 0 Spin.
2.
And touch the I button again.
3.
Programme end during rinse
hold
The I button flashes on the Touch-
Display, and the preset spin speed and
remaining programme length are
displayed for the selected programme.
Continue the programme by:
Touch the I button or
■
Change the spin speed (if
■
necessary) and then touch the I
button again.
If the water only needs to be
Note:
drained, touch the I button approx.
1 minute after the programme starts,
before the spin cycle begins. Then
switch the appliance off. The
programme is interrupted and the
door lock is released. The laundry
can be removed.
Operating the appliance

Programme end

End lights up on the Touch-Display and
I and Πdisplays are off.
Removing laundry/switching
off the appliance
Press the # button till the indicator
1.
lamp turns off, release the button.
The appliance is switched off.
Open the door and remove the
2.
laundry.
Turn off the tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Wipe the rubber seal dry.
■
Leave the door and detergent
■
drawer open so that any residual
water can evaporate.
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
en
33