Sony XAV-68BT Operating Instructions Manual page 8

Pairing and connecting with a
BLUETOOTH device
When connecting a BLUETOOTH device for the first
time, mutual registration (called "pairing") is
required. Pairing enables this unit and other devices
to recognize each other.
1
Press HOME, then touch [Settings].
2
Touch .
3
Touch [Bluetooth Connection], then set
the signal to [ON].
The BLUETOOTH signal of this unit is activated
and appears on the status bar.
4
Touch [Pairing].
The unit enters pairing standby mode.
5
Perform the pairing procedure on the
BLUETOOTH device to detect this unit.
6
Select "SONY:XAV-68BT" shown in the
display of the BLUETOOTH device.
7
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "passcode," "PIN code,"
"PIN number," "password," etc., depending on the
BLUETOOTH device.
8
Select this unit on the BLUETOOTH device
to establish the BLUETOOTH connection.
or lights up when the connection is made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected by another device. To enable
detection, terminate the current connection.
Connecting with a paired BLUETOOTH
device
This chapter explains how to connect manually to
registered BLUETOOTH devices.
1
Make sure that the BLUETOOTH signals
both on this unit (page 17) and the
BLUETOOTH device are activated.
on the status bar indicates that the
BLUETOOTH signal on this unit is on.
2
Operate the BLUETOOTH device to
connect to this unit.
or appears.
When the ignition is turned to on with the
BLUETOOTH signal activated, this unit searches for
the last-connected BLUETOOTH device, and
connection is made automatically if possible.
8
GB
Note
If this unit cannot detect the last-connected
BLUETOOTH device, touch [Reconnect] to search for the
last-paired device again.
If the problem is not solved, follow the pairing
procedure.
To install the microphone
To capture your voice during handsfree calling, you
need to install the microphone (supplied).
For details on how to connect the microphone, refer
to the supplied "Installation/Connections" guide.