Audiovox Jensen PS2130 Installation & Operation Manual page 7

PS260 / PS285 / PS2130 / PS2180
Wiring (continued)
Speaker Wiring
The Speaker Wiring diagrams illustrate the following four options for connecting speakers and
subwoofers to the PS amps:
• Two Speakers
• Two Subwoofers
• Bridged Subwoofer
• Tri-Mode
Note: When running a subwoofer and two full-range speakers together (tri-mode
operation), passive high and low pass filters must be used. Failure to install these filters
may cause damage to the amplifier and/or the speakers.
Two Speakers
Dos Altavoces
Deux Haut-Parleurs
4 ohm nominal
2 ohm minimum
Two Subwoofers
Dos Subwoofers
Deux Subwoofers
4 ohm nominal
2 ohm minimum
7
Passive High and Low Pass Filter Chart
Frequency
Hz.
2 Ohms
Inductor (L) Capacitor (C)
80 4.1mH 1000µF
100 3.1mH 800µF
130 2.4mH 600µF
200 1.6mH 400µF
250 1.2mH 300µF
400 0.8mH 200µF
600 0.5mH 136µF
800 0.41mH 100µF
1000 0.31mH 78µF
1200 0.25mH 66µF
1800 0.16mH 44µF
4000 0.08mH 22µF
Bridged Subwoofer
Subwoofer en Puente
Subwoofer En Pont
Speaker Impedance
4 Ohms 8 Ohms
Inductor (L) Capacitor (C) Inductor (L)
8.2mH 500µF 15mH
6.2mH 400µF 12mH
4.7mH 300µF 10mH
3.3mH 200µF 6.8mH
2.4mH 150µF 4.7mH
1.6mH 100µF 3.3mH
1.0mH 68µF 2.0mH
0.82mH 50µF 1.6mH
0.62mH 39µF 1.2mH
0.51mH 33µF 1.0mH
0.33mH 22µF 0.68mH
0.16mH 10µF 0.33mH
Tri-Mode
Tri-Modoa
Tri-Mode
L
Inductor
C
L
4 ohm minimum
Capacitor (C)
250µF
200µF
150µF
100µF
75µF
50µF
33µF
26µF
20µF
16µF
10µF
5µF
C
Capacitor