Philips 40PFL7705D User Manual page 42

Connecting a set-top box via a composite connector and
analog audio
IN IN IN
AUDIO L/R + VIDEO AUDIO L/R + VIDEO AUDIO L/R + VIDEO
Note
•
Only the left loudspeaker reproduces sound for mono equipment. Use a mono to
stereo adapter (not supplied) for sound reproduction via all internal loudspeakers.
•
When you connect cables, match the cable colors to the connectors on the TV.
Connecting the TV to the internet using an Ethernet cable
Ethernet cable h
Note
•
Please purchase shielded Ethernet cables at your local store and use them when you
connect to network equipment.
•
After connecting an Ethernet cable, set up necessary network settings. (For the
network setup, refer to 'Network' on page 30.)
•
Do not insert any cable other than an Ethernet cable to the Ethernet port to avoid
damaging the unit.
•
If your telecommunications equipment (modem, etc.) does not have broadband router
functions, connect a broadband router.
•
If your telecommunications equipment (modem, etc.) has broadband router functions
but there is no vacant port, use a hub.
•
For a broadband router, use a router which supports 10BASE-T / 100BASE-TX.
•
Do not connect your PC directly to the Ethernet port of this unit.
Cable Cable
OUT
RF IN
Set-top box Set-top box
LAN WAN
1 2 3 4 5
Hub or Hub or
broadband router broadband router
t bl ca
Internet t t
LAN
Ethernet cable hernet cable
Telecommunications Telecommunications
equipment (modem, etc.) equipment (modem, etc.)
Connecting the TV to the internet using a USB wireless
LAN adapter
USB wireless USB wireless wir
LAN ada LAN adapt LAN adapter AN d p pter
Note
•
After connecting a USB wireless LAN adapter, set up necessary network settings.
(For the network setup, refer to 'Network' on page 30.)
•
This unit is compatible with the supplied USB wireless LAN Adapter only.
(Commercially available USB wireless LAN adapters are not supported.)
•
Do not insert the supplied USB wireless LAN adapter when the unit is turned on.
Please insert the USB wireless LAN adapter when the unit is in the standby mode or
turned off.
•
Use a Wireless LAN Access Point (AP) (e.g. wireless router) which supports IEEE
802.11 b/g/n.
(n is recommended for stable operation of the wireless network.)
•
This unit does not support Ad-hoc mode.
•
Other radio devices or obstacles may cause interference to the wireless network
connection.
•
Do not use an extension cord and USB Hub to connect devices to this unit. Always
insert the USB fl ash memory or the supplied USB wireless LAN adapter in to this unit
directly.
Connecting a digital home theater amplifi er using a digital
audio coaxial cable
OUT OUT OUT
Note
Due to Copyright restrictions, the broadcaster may choose to mute PCM audio over
Digital Audio Output for certain channels, shows or segments during the broadcast.
WAN
Wireless LAN Wireless LAN
Access Point (AP) Access Point (AP) ( ( ) )
(e.g. wireless router) (e.g. wireless router)
Internet t t
LAN
Ethernet cable hernet cable
Network equipment Network equipment q p q p
(modem, etc.) modem, etc.) t
DIGITAL AUDIO
IN
digital home theater amplifi er digital home theater amplifi er
EN
41