Switching on and initial setup
Before you switch on the TV, check that the AC power cord is properly
connected. Press . POWER at the right side of the TV, or press
. (standby-On) on the remote control. The TV normally takes 25-30
seconds to start up and the following screen appears the fi rst time you
turn on the TV.
After you read a welcome screen, follow the on-screen instructions
to select your language and complete your TV setup. Installation takes
approximately 20 minutes.
Select your menu
language with the
Up/Down buttons on
your remote control,
press the OK button to
proceed.
Press Î / ï to select the desired mode for energy saving, then press
OK.
Location Home is recommended
for normal home use. In the
Retail Store location all settings
are fixed.
Select [Retail store] if you want backlight to be brighter.
Select [Home] to reduce power consumption.
You must set [Home]. Otherwise, personalized picture and sound
settings will not be memorized after the unit goes to standby mode.
Select [Retail store], the unit will be set up with predefi ned setting
•
for retail displays. In this setting, the power consumption may
possibly exceed the limited requirement of the ENERGY STAR
qualifi cation.
Select [Home], the unit will be set to maximize energy effi ciency.
•
Picture and sound settings can be adjusted and saved as per your
personal preferences.
Press Í / Æ to select [Start
[
], then press OK to begin
Settings assistant will allow you to customize your picture settings to
your personal preference. You will see a series of test pictures where
the right side and left side differ. Select the side that is most pleasing to
you with the Left/Right buttons.
Cancel
●
●
En
En
English
Engl
En
g
gl
gl
gl
gl
g
g
g
g
is
is
is
is
s
h
h
h
h
●
Français
●
Español
Retail store
Home
R R
[
[Settings assistant
K
Start
Select [Picture A] or [Picture B] by pressing Í / Æ that is the most
pleasing to you, then press OK. You see 5 different pictures to be
completed.
Which side of the picture do you prefer?
Cancel
Press Í / Æ to select [Store], then press OK.
Store your preferences.
Press OK to fi nish [ Settings assistant].
The TV has learned your preferences.
Press Í / Æ to select [Finish], then press OK.
Finish the Setup.
Note
•
If you are not receiving a signal from your cable service, contact the CATV provider.
•
If you press . during autoprogram, an installation will be canceled except the
language selection.
•
The initial autoprogram function can be executed for either [Antenna] or [Cable]
only once. When you change the connection (Antenna / Cable), set autoprogram again.
(Refer to page 35.)
®
].
Picture A
Picture A
Picture B
Cancel
Store
Exit
EN
11