Malfunctions; Acoustic Signal - schwa-medico AS SUPER 4 digital Instruction Manual

schwa-medico
Therefore, you may send back used batteries to us adequately stamped by mail or
render these at our warehouse free of charge at the following address:
schwa-medico GmbH, Wetzlarer Str. 41-43, 35630 Ehringshausen, Germany
Please refer to the following figures to see the respective symbols of batteries with
hazardous substances:
Battery contains more than 0.002 % cadmium
Battery contains more than 0.0005 % quicksilver
Battery contains more than 0.004 % plumb

Malfunctions

Please contact the schwa-medico service team or your dealer if problems arise
when using the AS SUPER 4 digital.
The AS SUPER 4 digital constantly monitors the correct connection of needles/
electrodes, cables and device. The device does not allow an increase in intensity in
excess of 4 mA, and automatically discontinues the stimulation if:
»
a needle/electrodes detaches itself from the skin
»
needles/electrodes are not connected correctly in pairs
»
needles/electrodes are not sufficiently conductive
»
the connection between the cables and the needles/electrodes is interrupted
»
the connection between the cables and the device is interrupted
The intensity then returns to 0 mA; this is indicated by a short acoustic signal.

Acoustic signal

The AS super 4 digital emits an acoustic signal at each
change of settings, switching ON/OFF and at the end of a
therapy session.
To switch OFF the acoustic signal press simultaneously the
key of channel 1 and channel 3 until the "beep" menu appears on the display.
Press the E key to switch ON and OFF the acoustic signal, press the key to get out
of the acoustic signal mode.
26
Operating Manual - AS SUPER 4 digital