Battery Charger; Control Panel - Husqvarna LC 141VLi Operator's Manual

LED display
Error LED flashes
Error LED is lit

Battery charger

LED display
Error LED flashes
Error LED is lit

Control panel

Keypad
Error LED flashes
Machine deactivates
71 - 001 - 03.11.2016
Possible faults
Battery discharged
Temperature deviation
Over voltage
Cell difference too much (1V)
Possible faults
Temperature deviation
Possible faults
Overload
If motor speed drops below a cri-
tical value, the motor will stop.
Motor control has overheated
Blade blocked.
Battery error or no signal from
battery
Battery discharged
Battery connector failure
Possible action
Charge the battery. See
113 .
Use the battery in surroundings where temperatures are
between -10°C and 40°C.
Check that the mains voltage corresponds with that sta-
ted on the rating plate on the product.
Remove the battery from the battery charger. Wait 5 se-
conds and try again to recharge the battery. If the pro-
blem persists, contact an authorised service agent.
Contact an authorised service agent.
Possible action
Use the battery charger in surroundings where tempera-
tures are between 5°C and 40°C.
Contact an authorised service agent
Possible action
Increase cutting height. See
page 112 .
Switch off the motor and wait until the motor has cooled
down.
Prevent unintentional start by turning the safety key to
"0", removing the battery and waiting at least 5 seconds.
Make sure the blade can rotate freely. If the problem per-
sists, contact an authorised service agent
Check that the battery is inserted properly and examine
the battery connector. If error LED flashes on the battery,
refer to the troubleshooting for battery. See
page 118 .
Charge the battery. See
113 .
Examine battery connector
To charge the battery on page
To set the cutting height on
Battery on
To charge the battery on page
119