Startup Wizard - Q-See QTN8019B Quick Start Manual

C. Turn on the NVR's power switch (if present). The NVR
may beep as it powers up. The Startup Wizard will
appear on-screen after a few minutes.
NOTE: The camera will make a faint clicking sound when
the power is activated. The cameras will take about one
minute after powering on to begin displaying on the monitor.
DISPLAY COMPATIBILITY: While the system boots, the
Q-See logo will appear. If the logo appears on your monitor
but goes blank, your display may not be compatible with
your NVR. This NVR requires a display capable of support-
ing 1024 x 768, 1280 x 720, 1280 x 1024, or 1920 x 1080.
Step 7: Startup Wizard
In order to effectively use the search functions and
maintain accurate recordings, you must complete the
Startup Wizard. To prevent the wizard from appearing
after each reboot, uncheck
Click on Wizard Setup to begin.
NOTE: If wizard does not pop up, shut down the NVR for
30 seconds and turn power back on.
Enable wizard next time.
9