Denon AVR-X2400H Owner's Manual page 246

Contents Connections Playback Settings Tips Appendix
z1 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played.
z2 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X or DTS signal is played.
z3 This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.
z4 This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z5 During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z6 This setting is available when "Subwoofer Mode" in the menu is set to "LFE+Main". (v p. 188)
z7 This item cannot be set when "Dynamic EQ" is set to "On". (v p. 149)
z8 This item cannot be set when Audyssey ® Setup (Speaker Calibration) has not been performed.
z9 This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input.
z10 This item cannot be set when "MultEQ XT" is set to "Off". (v p. 148)
®
z11 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
246
Front panel Display Rear panel Remote Index