Table of Contents
Advertisement
3.1.2 Configuring DiSEqC 1.2 settings
Your motorized antenna will turn toward your desired satel-
lites horizontally by DiSEqC 1.2.
To get the correct position of your desired satellite, take the
following steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the DiSEqC Command Mode option to User.
3. Set the Motor Control option to Goto. Then the antenna
will turn toward your selected satellite by the position
data that the digital receiver has.
4. If the receiving quality, which is displayed at the bottom
right of the screen, is not good, tune the antenna finely
with the Movement option. If you set it to 2(E), the an-
tenna will move to the east by two degrees. At this time
you had better check the receiving quality of every trans-
3.1 Searching broadcasting services 21
When you switch to a service, if it is not
provided by the current satellite, it will take
longer time than usual because the antenna
has to turn to its position.
To use the DiSEqC 1.2 protocol,
select the Installation > Motor-
ized DiSEqC 1.2 menu.
should see a screen like the left
figure. At first you have to set the
Motorized DiSEqC 1.2 option to
Enable.
You
Advertisement
Table of Contents
