Table of Contents
Advertisement
RR-US475E
33. The output is checked with an oscilloscope etc.
(L: 400Hz, R: 1kHz)
34. Insert the earphones.
35. Check the sound is output from the earphones.
(Volume is set as 13.)
36. Check the display of LCD is displayed as shown below.
37. Remove the earphones.
· To reset the unit to its initial factory setting (Initialization)
1. Press the [PLAY/STOP] switch for 10 seconds.
2. Check the display of LCD is displayed as shown below.
(Note: All indicators on LCD will switch off during formatting)
· Note: When there is failure in formating. The display of LCD is displayed as shown below:
Fig.15
Fig.16
Fig.17
Fig.18
10
Advertisement
Table of Contents
