Remote Loop Backs; Figure 28. D-Serv Lower Menu (Lm) - ADC Kentrox 78220 Operator's Manual

The D-SERV menu is divided into an upper section and a lower
section. The lower section can be viewed by typing LM.

Figure 28. D-SERV Lower Menu (LM)

D-SERV T1 DSU/CSU V1.01 Copyright (c) 1992 Kentrox, LLC
S
NSR / AHR
NCV
RLB
DRC
MM
LM>
The function of the commands listed in the D-SERV menu are the
same as the DataSMART DSU command functions. The response from
the D-SERV DSU/CSU will be different from the response from a
DataSMART DSU since the D-SERV DSU/CSU is not as feature rich.
The D-SERV DSU/CSU will respond to report requests from
DataSMART DSU for RUNLR, RUNSR, RCNLR, and RCNSR over
the Facility Data Link.
Refer to the DataSMART DSU Operator Manual for information on
the commands in the D-SERV menu, alarm parameters and reports.

Remote Loop Backs

A far end DataSMART or a test set can set a Line Loop Back (LLB), a
Data Port Loop Back (DPLB) or a Payload Loop Back (PLB) on the
D-SERV DSU/CSU (see codes on page 3). These loop backs can be reset
or overridden by the Loop Back Switch on the D-SERV DSU/CSU.
Refer to the DataSMART DSU Operator Manual for detailed
information on these loop backs.
NAME: PORTLAND, OR
- System Status Screen
- Network Statistical and Alarm History Report
- View Network Configuration
- Reset Loop backs
- Disconnect from Remote Unit Control
- Main Menu
Operator's Manual
41