Tail Circuit Timing Set Up; Figure 16. Tail Circuit Timing (Tct) Application; Figure 17. Cable #95010055 Pin Outs - ADC Kentrox 78220 Operator's Manual

Operator's Manual

Tail Circuit Timing Set Up

In order for tail circuit timing to function correctly:
Select the correct cross pinned cable for your application.
¤
Refer to page 25 for cables available from ADC Kentrox.
Refer to Figures 16 through 19 for pin outs.
The data port source bit rate (from a DataSMART unit or a
¤
MUX) must match the D-SERV data port bit rate set with
the DIP switches on S2.
On the D-SERV unit, set Switch S3 for Data Port Timing
¤
(S3-5 Down and S3-6 Up).
If you are connecting to a DataSMART unit, the
¤
DataSMART must be configured for data port external
clocking (the DCLK<your data port>:E command).

Figure 16. Tail Circuit Timing (TCT) Application

Figure 17. Cable #95010055 Pin Outs

32