Jumper Location And Access; Figure 12. Configuration Jumper Location - ADC Kentrox 78220 Operator's Manual

Operator's Manual

Jumper Location and Access

The configuration jumpers are located on the D-SERV card. Plug-in
units have the jumpers readily accessible.
To access the jumpers on a stand-alone unit:
Disconnect all power connections and interface cables
¤
Turn the D-SERV unit over, and using a phillips
¤
screwdriver remove the four screws connecting the two
sides of the case (see Figure 13 for location of screws)
Separate the case
¤
Set the jumper(s)
¤
Close the case and secure with the four screws
¤

Figure 12. Configuration Jumper Location

20