Grundfos Unilift KP 250 Installation And Operating Instructions Manual
Hide thumbs
Also See for Unilift KP 250:
- Installation and operating instructions manual (20 pages) ,
- Manual (12 pages) ,
- Technical data manual (6 pages)
Subscribe to Our Youtube Channel
Related Manuals for Grundfos Unilift KP 250
Summary of Contents for Grundfos Unilift KP 250
-
Page 1: Product, Unless They Are Under Supervision
GRUNDFOS INSTRUCTIONS Unilift KP 150, KP 250, KP 350 Installation and operating instructions Other languages http://net.grundfos.com/qr/i/96894217... -
Page 2: Table Of Contents
Operating conditions easier and ensure safe operation. 5.1 Sound pressure level 2. Unilift KP pumps Installation 6.1 Space requirements Grundfos Unilift KP pumps are available in these 6.2 Pump positions versions: 6.3 Pipe connection • Unilift KP-A with float switch (automatic 6.4 Start/stop level... -
Page 3: Pumped Liquids
3. Applications 5. Operating conditions Unilift KP 150, KP 250 and KP 350 are single-stage Liquid temperature submersible pumps designed for the pumping of Minimum 0 °C. grey wastewater. The maximum liquid temperature depends on the The pump can pump water with a limited content of rated voltage of the pump. -
Page 4: Installation
6. Installation 6.2 Pump positions Unilift KP-A and Unilift KP-M can be used in vertical Do not install the pump hanging from the position with the outlet pointing upwards. The pumps electric cable or the outlet pipe. may also be used in horizontal or tilted position with Caution Never lift the pump by the power supply the outlet as the highest point. -
Page 5: Start/Stop Level
Motors for Unilift KP 350, 3 x 200 V, 50 Hz, must be Unilift KP 150 A connected to a motor-protective circuit breaker. Unilift KP 250 A Three-phase pumps with float switch (Unilift KP-A) must be connected to the mains supply by means of Unilift KP 350 A a contactor. -
Page 6: Operation
6.5.1 Checking the direction of rotation 7. Operation Three-phase pumps only 7.1 Unilift KP-A Check the direction of rotation every time the pump is connected to a new installation. The pump will start and stop automatically, depending on the liquid level and the cable length of 1. -
Page 7: Maintenance
If the pump still delivers too little water, dismantle the 8. Maintenance pump further. Under normal operating conditions, the pump is 1. Disconnect the power supply. maintenance-free. 2. Remove the inlet strainer. See point 3 above. If the pump has been used for liquids other than 3. -
Page 8: Service
Order numbers for the ordering of service kits and contents of service kits appear from the tables below The cable and level switch must be and fig. 14. Note replaced by an authorised Grundfos service workshop. Pump type Part number Impeller kit... -
Page 9: Fault Finding The Product
This product or parts of it must be disposed of in an environmentally sound way: 1. Use the public or private waste collection service. 2. If this is not possible, contact the nearest Grundfos company or service workshop. Subject to alterations. - Page 10 Appendix Dimensions Unilift KP-AV Unilift KP-M 1 1/4 Rp 1 Rp 1 1/4 Unilift KP 350...
- Page 12 Argentina China Hong Kong Bombas GRUNDFOS de Argentina S.A. GRUNDFOS Pumps (Shanghai) Co. Ltd. GRUNDFOS Pumps (Hong Kong) Ltd. Ruta Panamericana km. 37.500 Centro 10F The Hub, No. 33 Suhong Road Unit 1, Ground floor Industrial Garin Minhang District Siu Wai Industrial Centre 1619 Garín Pcia.
- Page 13 Malaysia Serbia Turkey GRUNDFOS Pumps Sdn. Bhd. Grundfos Srbija d.o.o. GRUNDFOS POMPA San. ve Tic. Ltd. 7 Jalan Peguam U1/25 Omladinskih brigada 90b Sti. Glenmarie Industrial Park 11070 Novi Beograd Gebze Organize Sanayi Bölgesi 40150 Shah Alam Phone: +381 11 2258 740...
- Page 14 96894217 0716 ECM: 1187180 www.grundfos.com...
Need help?
Do you have a question about the Unilift KP 250 and is the answer not in the manual?
Questions and answers