Replacing A Hard Drive - Buffalo HD-QLU3R5 User Manual

Replacing a Hard Drive

The procedure for replacing a hard drive is shown below. After replacing the hard drive, reassemble by
performing the removal procedure in reverse.
1
The access LED for the failed hard drive number appears solid red. Make a note
of the access LED number. This is the number of the hard drive that will be
replaced.
2
Turn off the computer, and disconnect the DriveStation from the computer.
3
Turn off the DriveStation, and remove the AC adapter and USB cable.
4
The front cover is attached by magnets. Pull the cover straight off towards the
front.
5
Find the hard drive cartridge release lock for the number corresponding to
the glowing red access LED. To open the cartridge, pull it towards you while
pressing the tab to the left.
Note: When installing a new drive, press in the lock mechanism until it clicks into place.
①
②
Go to Next Page
HD-QLU3 User Manual
35