Mitsubishi Electric Q64RD User Manual page 79

4 SETUP AND PROCEDURES BEFORE OPERATION
4 - 11
1 The mode switching (normal mode to offset/gain setting mode to normal mode)
method is given below.

Dedicated instruction (G.OFFGAN)

Setting made to mode switching setting (buffer memory addresses 158, 159:
Un\G158, Un\G159) and turning the Operating condition setting request (Y9)
from OFF to ON Refer to Section 4.6 (2), (b)

Intelligent function module switch setting
(2), (c)
(After intelligent function module switch setting, reset the programmable
controller CPU or switch power OFF, then ON.)
2 Do not perform the following during the steps marked
If any of the following is performed, the data in E
the Q64RD/Q64RD-G may not operate normally.
• Powering off the programmable controller CPU
• Resetting the programmable controller CPU
MELSEC-Q
Refer to Section 4.6 (2), (a)
Refer to Section 4.5, Section 4.6
2.
2
PROM will have a problem and
4 - 11