Adjusting The Sound; Adjusting The Sound Level - Philips 28PW6826/05 Product Manual

w
Check that the mode selector on the side of the remote control is set to TV.

Adjusting the sound

H
& Press
, select the SOUND option (
L
press .The SOUND menu appears :
SOUND
• PICTURE
• LEVEL
• SOUND
• EQUALIZER
• FEATURES
• INSTALL
• SURROUND MODE
• DELTA VOLUME
• STORE
• AVL
• CORDLESS
• DELAY
IJ
é Use
keys to select a setting and keys
KL
to adjust.
Note: to access the AVL, CORDLESS and DELAY
settings (hidden at the bottom of the screen) hold
J
down key.The CORDLESS and DELAY settings
are only availables if surround loudspeakers are
connected to the TV set.The DELAY setting only
appears in DOLBY PRO LOGIC and HALL
SURROUND modes.
" Once the necessary adjustments have been
made, select the option STORE and press
to store them.
' To exit from the menus, press

Adjusting the sound level

This menu allows you to balance the sound
between the different speakers.
H
& Press
, select SOUND (
The SOUND menu appears :
SOUND
• PICTURE
• LEVEL
• SOUND
• EQUALIZER
• FEATURES
• INSTALL
• SURROUND MODE
• DELTA VOLUME
• STORE
• AVL
• CORDLESS
DELAY
é Select TEST and press
A continuous sound is emitted in turn from
each channel : left, right, centre and rear
8
J
) and
120 HZ
500 HZ
1500 HZ
5 KHZ
10 KHZ
L
R
.
J L
) and press .
TEST
BALANCE
CENTRE
REAR
L
to set it to ON.
Description of the settings:
• LEVEL: to balance the sound between the
different speakers (see below).
• EQUALIZER: to adjust the sound tone (from
bass: 120 Hz to treble: 10 kHz).
• SURROUND MODE: to select the different
surround modes (see next page).
• DELTA VOLUME (volume difference): allows
you to compensate for the volume differences
between the different programmes or the EXT
sockets.This setting is available for
programmes 1 - 40 and the EXT sockets.
• STORE: stores the sound settings.
• AVL (Automatic Volume Leveller): automatic
volume control used to avoid sudden
increases in volume, particularly when
changing programmes or during
advertisements.
• CORDLESS: to adjust the different parameters
of the cordless surround speakers (see p. 17).
• DELAY: to adjust the delay of surround effect
on the rear loudspedakers (31 is the default
value).
(depending on the selected surround mode).
Remark : the rear channel only appears if surround
speakers are connected to the TV set.To change
the surround mode, press the
" Select BALANCE, CENTRE or REAR and use
KL
the keys to adjust the level of each
channel independently.The sequence stops
while the level is being changed and then
automatically starts up again.
' To stop the test, press
Levels may also be adjusted without using the test
signal.
( To exit from the menus, press
)
key.
H
.
R
.