Yamaha ats-1010 Owner's Manual page 7

Installation: illustrated examples
Example 1 Example 2 Example 3
Example 1: Unit beneath TV
Example 2: Unit without stand beneath TV (_ P. 9)
Example 3: Wall mounting
Ir#6Ig-N
• Do not place the unit on/under any other components such
as BD player in a pile. The vibration of the unit may cause
system failure, etc. in other components.
• Depending on your installation environment, connections
to external components such as TV or BD player can be
done befk_re installing the unit. We recommend that you
temporarily place and arrange all components in order to
decide which procedure is best done first.
• When you clean the unit, use a clean, dry and snl: cloth
(such as cloth f_>r glasses).
•
Do not touch the grille on the frnnt and bottom nf the unit.
• Place the unit away from your TV more than 51) mm (2")
sn as not tn damage ynur TV with real" panel nf the unit.
The brackets on the rear nf the unit are removable.
1 Attach the supplied mounting template
on a wall and mark the holes of the
mounting template.
Tapes or
thum tac's k
/ Mark
^
2
Remove the mounting template and then
install the commercially available screws
and the supplied spacers at the marks.
!................................................................................................
"Spacer (5 mm (1/_4_2)---T-_
7 to 9 mm -_ -_ 4 mm (#81
(114" to 318")j__,_ ._-._:_, .....
,'_/,_J- L_ Minimum
2 to 4 mm 20 mm (3/4")
(1/16" to 3/16")
3
Hang the unit on the screws using the
brackets on the rear of the unit.
You can attach the unit to a wall using the brackets on the
rear of the unit.
When installing the unit on a wall, all
installation work must be performed by a
qualified contractor or dealer. The customer
must never attempt to perform this installation
work. Improper or inadequate installation
could cause the unit to fall, resulting in
personal injury.
• Do not attach the unit to a wall that is made of weak
materials such as plaster nr veneered woods. Doing so may
cause the unit to f:dl.
• Use commercially available screws that can support the
weight nf the installation.
• Make sure you use specified screws to attach the unit. Using
clamps ntber than specified screws, such as short screws,
nails, or two-sided tape, may cause the unit tn lhll.
• When connecting the unit, fix the cables in place where they
will not become loose. If your loot or hand accidentally gets
caught
on a loose
cable, the unit may lhll.
• Alter attaching the unit, check that the unit is fixed
securely. Yamaha will bear no responsibility li)r any
accidents caused by improper installations.
3 En