Table of Contents
Advertisement
_'lmfl_ff¢
The volume,
subwoofer
and
audio
delay time is not
adjustable.
The unit does not learn the
operation
of TV remote
control.
The a@lstment
has reached the n/axinmm
or
millimuln.
The remote control sensor of the unit may be
exposed to direct sunlight or lighting.
The scl_en glare of TV disturbs the remote
control signah
The batteries of TV remote control may be worn
out.
The button of the unit was not pl_ssed long
enough t_or the l_motc control learning
operation.
The TV remote control is not available tier
l_2ii/otc corltro] ]earrling.
The TV remote control is outside (if the
operation range.
The unit does not enler the remote conlro]
learning mode.
The power
state
of the unit
The power state of the unit and of your TV is
and of your TV is opposite,
opposite h'om the beginning.
(For example,
though
your
TV is on, the unit is in
standby
mode.)
The TV remote control is out
The unit and TV are too close/tar
lrom one
of work
even if you use TV
another.
remote
control relay
function,
Something
is between
the unit and your TV.
The TV remote control relay tilnction
is not
activated.
The TV remote control is not compatible
with
the TV remote control relay hmction.
You cannot
use 3D glasses.
The unit obstructs the 3[) glasses transmitler
of
your TV.
The picture
on your TV
The unit is to() close to your CRT TV.
screen becomes
blurred
or
distorted.
Reposition
the unit.
Disconnect
the power cable and pertbrm the
remote coiitrol learrling operation again.
Replace the batleries.
Plx:ss the button of TV remote control in the
order "plx:ss 1secorld"
_"release
1 second"
_
"press ] secorld"
Use the remote control of the unit.
Point your TV remote control towards the
remote control sensor of the unit keeping a
distance of 30 cm (I ft) between
them.
Operate after checking that the INPUT
indicator is flashing in red.
Press the power button of TV remote control to
set your TV and the unit to standby mode after
pressing the power button of your TV itself and
of the unit to set both your TV and the urlit to oil.
9
9
9
9
9
Try to use the TV remote control relay ltlrlctiorl
9
again after repositioning
the TV remote control
signal transmitter
(if the unit and the remote
conlrol serlsor of your TV.
Try to use the TV remote control relay hmction
9
again atler ac/iusting the height of the unit by
removing or atlaching its stands.
Remove the obstruction.
Restart the urlit arid check the indicator status.
9
Place the unit (without the stands, tbr example)
9
so
as
not
to
hide
the
remote
control
sensor
of
your TV.
Check the position (If 3[) glasses transmitter
(if
your TV by referring to the manual of your TV.
arid move the unit to the position where there is
IIO obstlllctiorl.
Move the unit away from your TV.
Contact
your nearest authorized
Yamaha
dealer or service center if the l'ollowing
problem
occurs.
13 En
- Quick Links:
- Setting Your Tv
Hide quick links:
Advertisement
Table of Contents
