Dirt Devil 360 REACH DDU03-E01 User Manual page 18

PROBLEM
Why does my
vacuum cleaner
have no power?
Why won't the vacuum
cleaner pick up?
Why won't the Powered
head brush turn?
Why is dust escaping
from the vacuum?
18
POSSIBLE CAUSE
The plug may not be fully pushed
into the electrical socket.
The motor thermostat may
have tripped.
The dirt container may not be
correctly fitted.
The shroud is not correctly fitted.
The filters may be clogged,
clean the filters.
The dirt container may be
blocked.
The brush on the powered head
has not been activated.
There maybe a blockage in the
reach wand.
The powered head brush has
not been activated.
The powered head may
be blocked.
The powered head has
not been re-set.
The filters may be clogged.
The shroud and separator may
be clogged.
POSSIBLE SOLUTION
Check the fuse in the plug if this
needs replacing, always replace
with a British 13amp fuse.
If this has happened, unplug the
vacuum cleaner. Remove and
empty the dirt container and check
the reach stick for blockages.
Clean the filters and allow the
vacuum cleaner to cool for
approximately 1 hour (if you have
washed the filters you will need to
wait 24 hours for the filters to fully
dry before putting them back into
the vacuum cleaner).
Remove the dirt container from the
vacuum cleaner and check it's
locked into place.
Go to 'How to clean shroud and
separator'.
Go to 'How to clean pre and post
motor filter'.
Empty the dirt container. Go to
'How to empty and clean the dirt
container'.
Activate the powered head. Go to
'How to use as a stick vacuum
cleaner'.
Remove the blockage. Go to 'How to
remove a blockage in the reach wand'.
Activate the powered head.
Go to 'How to use as a stick
vacuum cleaner'.
Clear blockage. Go to 'How to clean
a blockage from the powered head'.
Reset powered head. Go to 'how to
reset the powered head'.
Clean filters. Go to 'How to clean
pre and post motor filter'.
Clean shroud and separator. Go to
'How to clean shroud and separator'.