Table of Contents
Advertisement
PILOT LIGHTING PROCEDURE
Turn the Temperature Control Knob on the top of the unit to the OFF posiiton before attempting to light the pilot.
1. Turn the Gas Control Knob on the safety valve to the PILOT position.
2. Push down on the Gas Control Knob and light the pilot immediately by pressing the red button of the spark igniter.
Press the igniter every 2 seconds until a pilot flame is established� Hold the Gas Control Knob down for one full minute after
lighting the pilot�
3. Release the Gas Control Knob – the pilot flame should continue to burn. If the pilot flame does not remain lit, turn the
gas control valve to the OFF position, wait 5 minutes, and then repeat the steps above�
4. Once pilot is established, turn the Gas Control Knob on the safety valve (counterclockwise) from the PILOT to the
ON position. NOTE: failing to turn the gas control knob to the full ON position will reduce the flow of gas and could result in
poor ignition of the main burner�
5. Use the Temperature Control Knob on top of the Tandoor to control the height of the cooking flame. For Barrel
models, temperature control is located on the control box at the front end of the oven�
Plan view
FIRST FIRING
The first time the Tandoor is fired, the heat-up should be slow and steady� Hold the burner at a
very low flame (Temperature Control Knob set at "1" on models that are marked) for at least 8
hours with the lid on� Following this procedure will safely saturate the chamber with heat� You may
notice some small "crazing" cracks in the ceramic chamber after a few heat-ups and cool-downs�
Don't be alarmed as this is normal and will not affect the longevity or performance of the Tandoor�
M0054.05 APRIL 2017
An ongoing program of product improvement may
require us to change specifications without notice.
OPERATION
Tandoor CE Installation
and Operation Manual
Front view
Temperature
Control Knob
Drip/ debris pan
WOOD STONE CORPORATION
1801 W. Bakerview Rd.
Bellingham, WA 98226 USA
Gas Control Knob
Spark Igniter Button (Red)
Temperature Control Knob
+1.360.650.1111
TEL
E-MAIL
woodstone-corp.com
+1.360.650.1166
FAX
Lid
First firing setting
info@woodstone-corp.com
11
PG
OF
16
Advertisement
Table of Contents
