DO NOT LOWER STRIP FLASHING UNTIL TANDOOR IS LOCATED IN ITS FINAL INSTALLED POSITION
Screw holding up
flashing
Ü
Center punch and
pre-drill using the
existing hole as a guide,
then fasten with screw
10
M0054.05 APRIL 2017
PG
OF
16
LOWER FLASHING INSTALL (BARREL)
Protective black Edge Cover
Ü
Tandoor CE Installation
and Operation Manual
Leveling the Tandoor
Position Tandoor in its final installed position�
With the Flashing still in the UP position, level
the Tandoor using the four adjustable feet�
Plumbing the Tandoor
If the gas connection is made below the Tandoor,
plumb before lowering the flange�
If the gas connection is not from below the
Tandoor, it will be necessary to notch the flashing�
This should be done after the flashing
is lowered�
Lowering the Flashing
The unit ships with the Strip Flashing secured into
its "UP" position with a screw at each leg�
Remove the screw from all 4 legs and lower the
flashing evenly around the Tandoor, flat to the floor�
Center punch and pre-drill each Leg using the
existing hole in the flashing as a guide�
Secure the flashing at each leg using the screw
Ü
previously removed�
Remove the protective black Edge Cover�