Optional Accessories; Troubleshooting Jwb-10 Band Saw; Replacement Parts - Jet JWB-10 Operating Instructions And Parts Manual

12.0 Optional Accessories

Stock no. Application
707201 Scrollwork
707202 Resaw
707203 General purpose
707204 General purpose

13.0 Troubleshooting JWB-10 Band Saw

Symptom
Saw stops or will not
start
Does not make
o o
accurate 45 or 90
cuts
Blade wanders during
cut
Saw makes
unsatisfactory cuts
Blade does not come
up to speed
Saw vibrates
excessively

14.0 Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can usually be found at local hardware stores, or may be ordered from
JET.
Some parts are shown for reference only, and may not be available individually.
Length
67.5 in.
67.5 in.
67.5 in.
67.5 in.
Possible Cause
Saw unplugged
Fuse blown, or circuit breaker tripped
Cord damaged
Stop not adjusted correctly
Angle pointer not set accurately
Fence not aligned with blade
Warped wood
Excessive feed rate
Incorrect blade for cut
Blade tension not set properly
Guide bearings not set properly
Dull blade
Blade mounted wrong
Gum or pitch on blade
Incorrect blade for cut
Gum or pitch on table
Extension cord too light or too long
Low shop voltage
Base on uneven floor
Bad v-belt
Motor mount is loose
Loose hardware
Width Thickness
0.125 in. 0.025 in.
0.5 in. 0.032 in.
0.5 in. 0.025 in.
0.25 in. 0.025 in.
Correction
Check plug connections
Replace fuse, or reset circuit breaker
Replace cord
Check blade with square and adjust stop
Check blade with square and adjust pointer
Check and adjust fence
Select another piece of wood
Reduce feed rate
Change blade to correct type
Set blade tension according to blade size
Review guide bearing adjustment
Replace blade
Teeth should point down
Remove blade and clean
Change blade to correct type
Clean table
Replace with adequate size and length cord
Contact your local electric company
Reposition on flat, level surface
Replace v-belt
Tighten motor mount hardware
Tighten hardware
14
TPI
18TR
4HK
6HK
6SK