More - Kongsberg V series User Manual

Reverse Score
Enable this check box to specify that the tool shall work on the front side of the material.
Stop Before Use
When this function is enabled, the execution will stop at the beginning of this line and an operator
message is displayed.
The text to be displayed is entered into the User-defined text: – field.
Note:
Enable Sequencing if Stop before use is used in combination with Multi-pass
Knife lift angle
If the change in direction is above this value (in degrees), the tool is lifted.
If the knife tool has a lag, the knife lift angle is 14 degrees.
Perf pattern

13.6 More

Job Setup->More
Specify a perforating pattern in the two edit boxes.
The first specifies a tool up length and the second a tool down
length.
13
V-series
89