Input File - Kongsberg V series User Manual

11

11.16 Input File

Input file formats
Select one of the available formats in the drop down list.
ACM is the standard CAM format.
The formats available are:
File extension Description
.acm
.plt
.dxf
.ard
.cf2
.ddes
Standard file extensions will be automatically recognized.
Setup
Enter this dialog for advanced input file format setting.
For ACM and HPGL, use the setup dialog to specify the programming increment for the input file.
For DXF, CF2, DDES, ARD, see ArtiosCAD User manual for more information.
Enable CAD-X
CAD-X enabled allows for the following input formats in addition to the formats mentioned above:
DXF, CF2, DDES, ARD.
If none of these formats are used, leave the function disabled.
Origin in lower left corner
Causes the entire input file coordinates to be offset, using the lower left corner of the job as reference.
The lower left corner of the job will now always be in the selected Reference Point.
Note! i-cut and ArtiosCAD users should leave this function OFF.
72
Options->System Option->System->Input File format
Kongsberg acm – format. This is the default input format for Kongsberg XP.
Described in the Technical Reference manual for XP.
HPGL. Described in the Technical Reference manual for XP.
DXF. See Appendix about DXF input tuning (193).
ArtiosCAD. See Appendix about the ArtiosCAD module CAD-X (193).
CF2. See Appendix about the ArtiosCAD module CAD-X (193).
DDES. See Appendix about the ArtiosCAD module CAD-X (193).
V-series