Table of Contents
Advertisement
18. Maintenance
18.1 Daily maintenance
• Inspect the equipment in order to prevent any irregularities.
• The table surface should be kept clean at all times.
• The room should be cleaned regularly.
• Use a vacuum cleaner to keep the inside of the conveyor belt clean.
18.2 Weekly maintenance
The guide-ways and the bearings should be thoroughly cleaned and oiled very lightly.
The automatic draining action of the air pressure reduction valve should be controlled:
• Switch off the air compressor and allow the air pressure to fall.
• Switch on the air compressor and check that any water in the glass bowl of the pressure reduction
valve drains out automatically during the first few seconds of operation.
• Remove and clean the bowl if the automatic draining action does not operate or if it appears to
be an excessive amount of dust in the bowl.
18.3 Maintenance, external equipment
All external equipment, as PC, Vacuum pump and compressor should be maintained according to
the User Manual for the actual equipment.
More information about maintenance is available in the Maintenance Manual.
Warning
Main Power should be switched off before cleaning is carried out.
18
V-series
161
Advertisement
Table of Contents
