Assembling The Lance; Connecting The Water Outlet - Malmbergs LHG-30116M Instruction Manual

ASSEMBLING THE LANCE

Connect the nozzle and the lance (6 & 7)
by pushing the bayonet on the nozzle (6)
into the socket of the lance (7) and as-
semble into position (rotating clockwise
until it locks in place). The assembly must
be carried out prior to using the pressure
washer. Ensure that both parts are firmly
connected together otherwise the nozzle
could fly off the lance.
Always remove or replace parts while the
pressure washer is switched off.

CONNECTING THE WATER OUTLET

1
5 4
Screw the high-pressure hose (5) onto the high-pressure water outlet (4).
Ensure that the connector is firmly fastened (but do not overtighten).
The minimum length of supply hose (not included) advised for maximum
user convenience is 5 metres with a diameter of 12.5 mm (1/2") to avoid
back pressure and any associated potential damage to your pressure washer.
INSTRUCTIONS fOR USE
1. fully open the water mains tap – do not at this point switch on your
pressure washer. Never operate your pressure washer without the water
supply switched on.
2. do not lock the pistol during the operation.
3. Hold the trigger of the pistol grip (6) until all the air has been expelled
2
3
7
6
21