Mitsubishi Electric MSZ-LN25VGW Service Manual page 44

OPERATING PROCEDURE
6. Removing the outer vane motors
(horizontal) (Photos 8, 10, 11, 12, 13)
(1) Remove the front panel, the outer vanes (R) (L)(hori-
zontal), the panels (U) (R) (L) (F), the corner boxes
(R) (L), Wi-Fi interface, DISPLAY and i-see SENSOR
ASSEMBLY, V.A. clamp, and the electrical cover.
(2) Remove the following connector (Photo 8):
<Indoor electronic control P.C. board>
CN151 (Vane motors)
(3) Pull out the drain hose from the nozzle assembly.
(4) Pull and remove the nozzle assembly (catches on left,
right, and center) (Photo 10).
(5) Cut off the cable tie to secure the lead wires on the
right side of the nozzle assembly (Photo 12).
(6) Remove the tape to secure the lead wires and the
aluminum tape on the front of the nozzle assembly
(Photo 11).
Removing outer vane motor (R) (horizontal) (Photo 12)
(7) Loosen the lead wires, and disconnect the connector
of the outer vane motor (R) (horizontal).
(8) Remove the 2 screws of the outer vane motor (R)
(horizontal).
(9) Remove the outer vane motor (R) (horizontal).
Removing outer vane motor (L) (horizontal) (Photo 13)
(10) Loosen the lead wires, and disconnect the connector
of the outer vane motor (L) (horizontal).
(11) Remove the 2 screws of the outer vane motor (L)
(horizontal).
(12) Remove the outer vane motor (L) (horizontal).
OBH766
Photo 10
Photo 13
Catches of nozzle assembly (3 places)
Photo 11 (Front view of nozzle assembly)
Tape to secure the lead wires
Photo 12 Outer vane motor (R) (horizontal)
Photo 13 Outer vane motor (L) (horizontal)
Outer vane motor (L) (horizontal)
44
PHOTOS
Photo 12
Aluminum tape
Cable tie
Outer vane motor (R) (horizontal)
Screws
Screws