Mitsubishi Electric MSZ-LN25VGW Service Manual page 17

(4) Press button to complete and transmit the weekly timer setting.
NOTE:
• Press button to transmit the setting information of weekly timer to the indoor unit. Point the remote controller toward the
indoor unit for 3 seconds.
• When setting the timer for more than one day of the week or one number,
setting. Press button once after all the settings are complete. All the weekly timer settings will be saved.
button to enter the weekly timer setting mode, and press and hold
• Press
timer settings. Point the remote controller toward the indoor unit.
(5) Press button to turn the weekly timer ON. (
•When the weekly timer is ON, the day of the week whose timer setting is complete, will light.
Press button again to turn the weekly timer OFF. (
NOTE:
The saved settings will not be cleared when the weekly timer is turned OFF.
2. Checking weekly timer setting 2. Checking weekly timer setting
(1) Press button to enter the weekly timer setting mode.
* blinks.
(2) Press or
(3) Press button to exit the weekly timer setting.
NOTE:
When all days of the week are selected to view the settings and a different setting is included among them,
displayed.
9-9. i-see CONTROL ( ) MODE AND ABSENCE DETECTION
In the i-see control mode, the room temperature is controlled based on the sensible temperature.
(1) Press SENSOR button with a thin instrument during COOL, DRY, HEAT and AUTO mode to activate i-see control mode ( ).
The default setting is "active".
(2) Press SENSOR button several times to cancel i-see control mode.
NOTE:
Any person at the following places cannot be detected:
• Along the wall on which the air conditioner is installed
• Directly under the air conditioner
• Where any obstacle, such as furniture, is between the person and the air conditioner
A person may not be detected in the following situations:
• Room temperature is high.
• A person wears heavy clothes and his/her skin is not exposed.
• A heating element of which temperature changes signifi cantly is present.
• Some heat sources, such as a small child or pet, may not be sensed.
• A heat source and the air conditioner are more than 6 m apart.
• A heat source does not move for a long time.
Do not touch the i-see SENSOR. This may cause malfunction of the i-see SENSOR.
The intermittent operating sound is a normal sound produced when the i-see SENSOR is moving from side to side.
OBH766
* which was blink-
ing goes out, and the
current time will be
displayed.
buttons to view the setting of the particular day or number.
lights.)
goes out.)
17
button does not have to be pressed per each
button for 5 seconds to erase all weekly
will be